mas cambios
Active Member
How to use a gripping cone
Although this will be teaching many of you to suck eggs, one or two of you have asked for tips on using a gripping cone so below is quick guide with pictures.
Firstly -a gripping cone!
Before you start it's a good idea to check the binding on the handle, make sure there are no loose ends and it's not starting to unravel. If it is you can stick down the loose bits with a little bit of wood glue. If the string has come away completely you need to get it rewound by a pro.
You need to place the grip as far onto the cone as you're able - don't force it on but you should get about 2/3 of the grip on, like so:
Once you've done that roll the grip upwards (as per arrow on photo) until the grip 'pops' off:
Turn the half rolled grip around and place the unrolled bit back onto the cone, until the rolled up section is back on and then roll the grip down:
Continue to roll the grip down the cone, towards the metal ring (if your cone has one). It should look something like this:
Once you are near or on the metal ring, place that end over the handle of the bat (you need to grip the bat with your feet to free up your hands) and push the grip over the bottom of the cone and onto the handle. It may take some force, depending on the age of the grip and how thick it is:
Proceed to roll the grip all the way down the handle - try to get the bottom of the grip to fall where the handle meets the bat (this will take practice). If you don't get it first time, you'll need to play with the grip to get it to fit. Use your thumbs and palms to work the grip.
Lastly, roll the grip all the way up the handle. You can 'pat' down a small amount of excess using the flat of you palm. If its a lot then you can again work the grip using your hands. If the grip comes up short, roll it down the handle and then back up to stretch it.
To finish off you can place some electrical tape on the base of the grip (wrap it twice round, keeping the second wrap over the first) but it's not critical.
I hope that explains the basics, after that its down to practice and blisters on your palms! Apologies for the pictures being slightly blurry but I had to take them on a camera phone.
Although this will be teaching many of you to suck eggs, one or two of you have asked for tips on using a gripping cone so below is quick guide with pictures.
Firstly -a gripping cone!
Before you start it's a good idea to check the binding on the handle, make sure there are no loose ends and it's not starting to unravel. If it is you can stick down the loose bits with a little bit of wood glue. If the string has come away completely you need to get it rewound by a pro.
You need to place the grip as far onto the cone as you're able - don't force it on but you should get about 2/3 of the grip on, like so:
Once you've done that roll the grip upwards (as per arrow on photo) until the grip 'pops' off:
Turn the half rolled grip around and place the unrolled bit back onto the cone, until the rolled up section is back on and then roll the grip down:
Continue to roll the grip down the cone, towards the metal ring (if your cone has one). It should look something like this:
Once you are near or on the metal ring, place that end over the handle of the bat (you need to grip the bat with your feet to free up your hands) and push the grip over the bottom of the cone and onto the handle. It may take some force, depending on the age of the grip and how thick it is:
Proceed to roll the grip all the way down the handle - try to get the bottom of the grip to fall where the handle meets the bat (this will take practice). If you don't get it first time, you'll need to play with the grip to get it to fit. Use your thumbs and palms to work the grip.
Lastly, roll the grip all the way up the handle. You can 'pat' down a small amount of excess using the flat of you palm. If its a lot then you can again work the grip using your hands. If the grip comes up short, roll it down the handle and then back up to stretch it.
To finish off you can place some electrical tape on the base of the grip (wrap it twice round, keeping the second wrap over the first) but it's not critical.
I hope that explains the basics, after that its down to practice and blisters on your palms! Apologies for the pictures being slightly blurry but I had to take them on a camera phone.
A_A, you are the legend of tutorials 
